Split from the Aqua-logic salt too high-cholrinator off high salt/amps topic. Bama
I'm having the same exact problem, but did not find any weak or burnt looking soldering points...Also, the back of my board looks a little different then the one pictured. I have a Pintair MiniMax NT Model # 400 DV.
Im also getting High salt/Amps.
Reads 40.64V 10.04A 68F 2300 PPM
I also recently replaced my Hayward Goldline T-cell-15 about a month ago and it has was working fine....Now a month later I'm getting the error.
Any other ideas?
Thanks, Dan
Any other ideas?
I'm having the same exact problem, but did not find any weak or burnt looking soldering points...Also, the back of my board looks a little different then the one pictured. I have a Pintair MiniMax NT Model # 400 DV.
Im also getting High salt/Amps.
Reads 40.64V 10.04A 68F 2300 PPM
I also recently replaced my Hayward Goldline T-cell-15 about a month ago and it has was working fine....Now a month later I'm getting the error.
Any other ideas?
Thanks, Dan
Any other ideas?