Hi,
I am new to this forum but I hope you can help me here...
I have the salt system with an SC-36 cell. The control panel is blinking with "Clean Cell/ Low volt" message. The part that concerns me is that the electric cord that goes from the panel to the Cell (that goes to the 2 big "nails" in the cell) is kind of melting from the inside.. from the outside it looks fine. When I disconnect the cord from the cell and look in the 2/3 holes in the cord, I see like a black gel. this gel can also be seen dripping by the cell...
It started about 1 year ago ( I think), I found about when the cord was all damaged and I replaced it by a new one a few months ago, I just checked it today and this one is also "melting" and if this has to do with the error message in the panel.
Any ideas why this is happening?
Thanks in advance!
I am new to this forum but I hope you can help me here...
I have the salt system with an SC-36 cell. The control panel is blinking with "Clean Cell/ Low volt" message. The part that concerns me is that the electric cord that goes from the panel to the Cell (that goes to the 2 big "nails" in the cell) is kind of melting from the inside.. from the outside it looks fine. When I disconnect the cord from the cell and look in the 2/3 holes in the cord, I see like a black gel. this gel can also be seen dripping by the cell...
It started about 1 year ago ( I think), I found about when the cord was all damaged and I replaced it by a new one a few months ago, I just checked it today and this one is also "melting" and if this has to do with the error message in the panel.
Any ideas why this is happening?
Thanks in advance!