- Jul 27, 2009
- 20
- Pool Size
- 15000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
I just had a new EcoStar VSP installed to replace my 1.5HP Jandy Stealth. The timer that was being used to control the old pump and SWG was taken out of the equation. The SWG is now "on" all the time, but not really doing anything unless there is flow (?). This morning, the SWG threw flow errors (172\186) when the pump fired up. I fixed it by increasing the RPMs on the pump. Are there any suggestions or experience with his configuration? Is it bad for the Aquapure? Are there any numbers\suggestions on the lowest RPM setting I can get away with on the pump and not error out the SWG?
(have to update my sig for the new pump, and the removal of the solar panels)
Thanks
(have to update my sig for the new pump, and the removal of the solar panels)
Thanks