I put in an EasyTouch system earlier this summer. After wiring and getting everything running, the LCD on Intelliflo VF pump display was minimal. Unplug the communications cable from the EasyTouch, was unable to change the pump back to the full feature menu. Researching it, the "VF" pump when hooked up to a "1.x" motherboard will cause it to look and act like a "VS" pump. I have since replaced the MB for a 2.x version which has the support for "VF" pumps. But can not find a procedure for resetting the "VF" pump back to factory defaults.
Found hints that key presses are required followed by disconnection of the control from the pump.
If someone is has this super secret procedures for this, it would be greatly appreciated.
Found hints that key presses are required followed by disconnection of the control from the pump.
If someone is has this super secret procedures for this, it would be greatly appreciated.