Newcomer here. Thanks for providing this venue.
Had a bad board (per Goldline tech support) and replaced controller with a new AquaRite Pro control box (Aqua Chem 1&2 to be added later and kept 5 yr old T-15 cell and flow switch). All seems to be working great but....sometimes when I look at the readout on the front of the controller, it shows 0.0 volts and 0000ppm salt and "0" amps. The only logical thing I can come up with is that we're set on 60% generation and that I'm looking at it when it is in the 40% and not generating. Does that make any sense to anyone? I haven't found any reference to this issue elsewhere.
Thanks,
Chip
Had a bad board (per Goldline tech support) and replaced controller with a new AquaRite Pro control box (Aqua Chem 1&2 to be added later and kept 5 yr old T-15 cell and flow switch). All seems to be working great but....sometimes when I look at the readout on the front of the controller, it shows 0.0 volts and 0000ppm salt and "0" amps. The only logical thing I can come up with is that we're set on 60% generation and that I'm looking at it when it is in the 40% and not generating. Does that make any sense to anyone? I haven't found any reference to this issue elsewhere.
Thanks,
Chip