1st test, newbie

Add the CYA, and the bleach... when the cya is dissolved, re-test for Ph.

CYA is a mild acid, and it will knock your Ph down a bit.
 
Have you added the salt yet for your SWG?

Do you have a test for salt levels?

Bring your FC up with bleach... confirm that FC is correct (test)... then turn your SWG on. That way, all your SWG has to do is to maintain the chlorine level for your pool, and doesn't have to kill itself trying to bring it up from nothing.

please update your signature to tell us that you have the TF100 kit (I saw the instruction sheet in your picture, and recognized it).
 
Your in sunny FL so you may burn through FC quickly until you CYA gets dissolved, some down there run a CYA of 40-50. I would set your target at 10 FC and let it fall down to 4-5 area and maintain it there until you get a chance to add salt and get the SWG up an running. Use the FAS-DPD test out lined here to make sure you reach 10 or close to it. It should take about 15-30 minutes after you add the liquid chlorine to get there.
 
I'm working from your earlier FAS-DPD result but your travelling a bit low on the FC, you want to get it up around 6 FC perhaps even a little higher if your losing it quickly until you can get your SWG going and raise the CYA. See the FC/CYA chart. You never want to be getting your FC below the minimum level.
 

Enjoying this content?

Support TFP with a donation.

Give Support
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.