I fixed my SWG K1 relay solder issue this weekend thanks to the thread on here about it. Right after we put the panel back on, screwed it down, etc, i noticed that the pump would run on hi speed but not on low speed. With the timer having it on at low, it's off, change the timer so the hi speed should run and it runs on high. Pressing the filter button will change from Off to High to Low. Only runs on high now.
I checked to see if anything was pulled loose during the K1 solder fix (as the pool temp wire came loose after the fix and we solved it) but can't find anything related to the pump.
Anybody else had this happen - One speed only working on the pump?
I checked to see if anything was pulled loose during the K1 solder fix (as the pool temp wire came loose after the fix and we solved it) but can't find anything related to the pump.
Anybody else had this happen - One speed only working on the pump?