Just opened my pool a couple days ago and I can't tell where the problem is. Green power light is lit at all times, Red no flow is full with start up but eventually disappears. None of the other lights come on to indicate check cell, chlorinating, ect. I replaced the fuse and it's the same situation. The box display is stuck on 3000, which is probably the last measurement it was turned off with.
Could this be a flow switch problem, control panel or cell? Thanks for your assistance in advance.
I should also state the pool is getting good flow and is above 75 degrees.
Could this be a flow switch problem, control panel or cell? Thanks for your assistance in advance.
I should also state the pool is getting good flow and is above 75 degrees.