New pool/spa build. Partial perimeter overflow spa. That is, the spa is raised and approx 3/4 spills into the pool. (the rest is outside of pool and raised above concrete patio). The overflow of the spa was a 'during construction' change.
Pentair equipment
When we turn the spa on (particularly with jets on), and get in, the water level is too high and spills not only into pool but also onto concrete patio. We can manually lower the spa water level by turning the check-value to push the water back to the pool for 1 min or so. And then we get in heated spa and turn on jets and all is fine.
But we think there has got to be a plumbing/equipment solution (and corresponding programming solution (we think we can use Aux on pentair phone controller)) that works better.
Thoughts? Check valve? New circuit?
Hope that makes sense.
Thanks!
Pentair equipment
When we turn the spa on (particularly with jets on), and get in, the water level is too high and spills not only into pool but also onto concrete patio. We can manually lower the spa water level by turning the check-value to push the water back to the pool for 1 min or so. And then we get in heated spa and turn on jets and all is fine.
But we think there has got to be a plumbing/equipment solution (and corresponding programming solution (we think we can use Aux on pentair phone controller)) that works better.
Thoughts? Check valve? New circuit?
Hope that makes sense.
Thanks!