We have a 4.5' wide spa spillover. After finishing our build, the spillover was a full sheer waterfall. After a couple of weeks, it now trickles under the spillover and down the glass tile front of the spa as soon as the pool is turned on. As soon as we splash it by hand, it goes to full sheer waterfall. I've tried maxing pump speed for priming and even for running with no luck. We've gone from chlorine to salt and back to chlorine over the past 30-60 days as we were going through new plaster startup and now doing a refinish (no point in continuing to waste salt).
Our spillover has a nice sharp edge, not rounded.
Is this just water pressure related? Maybe I need to clean my filter more frequently if I want this spillover effect? Could the water chemistry impact it? Viscosity? It seemed to do it better with salt (or maybe I'm crazy?)
Any other thoughts? I figured I'd ask now while we are refinishing later this week. Thanks!
Sent from my iPhone using Tapatalk
Our spillover has a nice sharp edge, not rounded.
Is this just water pressure related? Maybe I need to clean my filter more frequently if I want this spillover effect? Could the water chemistry impact it? Viscosity? It seemed to do it better with salt (or maybe I'm crazy?)
Any other thoughts? I figured I'd ask now while we are refinishing later this week. Thanks!
Sent from my iPhone using Tapatalk