Hi Everyone,
This Thursday I was given the ok by my PB to run the heater. I opened all of the natural gas valves, followed the instructions on the inside of the heater for starting it up, and updated the configuration with the aqua logic configuration menu to control heater1. However, I am not able to control the spa or pool temperature through the control panel. Did I miss any steps?
While running in pool mode, I switch to spa which I setup to go to 95 degrees. Nothing happens with the heater. If I change the temperature on the remote to a higher temperature, it doesn't turn on unless I go over to the heater and manually adjust the heat.
Sent from my iPhone using Tapatalk
This Thursday I was given the ok by my PB to run the heater. I opened all of the natural gas valves, followed the instructions on the inside of the heater for starting it up, and updated the configuration with the aqua logic configuration menu to control heater1. However, I am not able to control the spa or pool temperature through the control panel. Did I miss any steps?
While running in pool mode, I switch to spa which I setup to go to 95 degrees. Nothing happens with the heater. If I change the temperature on the remote to a higher temperature, it doesn't turn on unless I go over to the heater and manually adjust the heat.
Sent from my iPhone using Tapatalk