A few weeks ago, I had my Aqualink RS-8 primary PCB go out after some wires shorted in the control cabinet. As the PCB was no longer available nor was there an alternate, I had no option but to upgrade to the iAquaLink 2.0, Rev T PCB. I followed the directions included in the upgrade kit any everything works great...except my Jandy LXi pool and spa heater.
There is nothing on the Jandy LXi pool heater display nor are any of the lights on. It is almost as if there is no power to the pool heater but that can't be the case as I didn't do anything with the control panel wiring; only replaced the primary PCB. The instructions with the iAquaLink 2.0 upgrade kit didn't mention anything about changing any of the dip switches and everything works great except for the heater.
When we enable the heater, no lights nor noises can be heard but it does seem like we can barely smell some gas. I have no idea what settings in the software or on the PCB board might be necessary to get my pool and spa heater working.
I would appreciate any and all help in solving this problem.
There is nothing on the Jandy LXi pool heater display nor are any of the lights on. It is almost as if there is no power to the pool heater but that can't be the case as I didn't do anything with the control panel wiring; only replaced the primary PCB. The instructions with the iAquaLink 2.0 upgrade kit didn't mention anything about changing any of the dip switches and everything works great except for the heater.
When we enable the heater, no lights nor noises can be heard but it does seem like we can barely smell some gas. I have no idea what settings in the software or on the PCB board might be necessary to get my pool and spa heater working.
I would appreciate any and all help in solving this problem.