- Dec 10, 2010
- 22
Was getting the "no flow" with no error codes on a Jandy AquaPure 1400 system. Tried cleaning the filter and the sensor - as well as removing the jumper and hitting the white calibration button on the daughter card to no avail. Ordered a new Tri-Sensor - got the R0452500 model - newer one that doesn't use the daughter card and has the module that sits outside the control panel box. Installation was straight forward - no issues - according to the instructions - and the firmware - i set the control module to Pgm B. The sensor is now getting Flow - everything looks good except - i cannot set the Production Rate on the Control Panel LED - it is stuck at 00% and subsequently the "Cell On" light does not come on. i tried switching to Pgm A - same result. Any ideas? Thanks ....