- May 21, 2015
- 157
- Pool Size
- 33000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 700
Hello all!
Once again, I am seeking guidance as pool water reading make no sense. My current readings are as follows:
Temperature 85
FC 9 I know is a bit high. My SWG was at 65 % due to heat wave in past weeks, I increased production a bit. Now is off until FC get back down
CC 0.5 Shall not be this high as my FC has never dropped below 2 PPM
TA 70
CH 400 Seems to keep going up depiste rain water and every three week back washes
CYA 70 so I think as the dot is obscure, but I can always see it. Based on Stabilizer added and rain/bashwash, etc it seems about right.
My CC shall not be 0.5 if my FC has always been not less than 2PPM (not longer than a day) as I check my water daily. Also my CH is concerning as just 1 week ago it was 375 and since we had rain water a few times, so it shall have decrease CH not increase. Please advice.
Once again, I am seeking guidance as pool water reading make no sense. My current readings are as follows:
Temperature 85
FC 9 I know is a bit high. My SWG was at 65 % due to heat wave in past weeks, I increased production a bit. Now is off until FC get back down
CC 0.5 Shall not be this high as my FC has never dropped below 2 PPM
TA 70
CH 400 Seems to keep going up depiste rain water and every three week back washes
CYA 70 so I think as the dot is obscure, but I can always see it. Based on Stabilizer added and rain/bashwash, etc it seems about right.
My CC shall not be 0.5 if my FC has always been not less than 2PPM (not longer than a day) as I check my water daily. Also my CH is concerning as just 1 week ago it was 375 and since we had rain water a few times, so it shall have decrease CH not increase. Please advice.
Last edited: