Been gone on vacation and pool hasn't been checked in 2 weeks, temp has gone up in last few weeks and I guess thats what did me in. Got home overnight and this morning immediately saw green gunite pool. On closer observation water was clear just green on walls and especially floor. Checked SWG and flashing no salt. Mine doesn't have digital reading, just flashes if low, (Intellichlor). Checked with my taylor kit and ph.8, FC pretty nonexistent. Took water to pool store because I knew I needed to get acid and salt at least. I ran out of solution for Cya test but store said it was 50 a little over a month ago. I just was going to let them check CYA since I didn't think added that very often. Their results by computer today were FC 0, ph 8.6, calcium 202, alk 90, Cya16, copper 0, iron 1, salt 2860. They said to add 1/2 of 6lb bottle CYA today and gallon of muriatic acid to get way ph down. Then to add yellow out and 2( 1 lb) packs of shock. Wife wanted me to do what store said and not add bleach but I decided to try and attempt a SLAM. Ive been checking pool every 2 hours and haven't been able to get FC greater that 1.5-2. So far I've added 8 gallons of bleach as well as the 2 shocks. When I put the r-0870 2 scoops have to stir it around awhile before turns pink and then doesn't take much 871 to get clear. Usually immediatly turns pink when scoops go in. Just went back and it was turned back pink again, didn't dump it after checking last time, is that normal? I usually immediatly dump it. Pool bottom was clearing up well where the shock went on bottom. I brushed it about 2 hours ago and pool is still green and can't even see bottom in shallow end. I maybe shouldn't have brushed it yet. Should I just let it rest and check it tomorrow or keep adding bleach?