So we decide to get an above ground pool something we have been wanting to do for a few years now. We picked out a 12' X 48" bestway steel framed one. We levelled out all the ground by moving the dirt form the higher point to the lower point (which we know now isn't the best way to do this) we then covered it with a layer of sand and set the pool up, we put patio slabs that are about an 1.5" tall under each leg but we couldn't get them all completely straight which was the first issue. We then started to fill the pool up only to are disappointment to find it is unlevel by about 3 inches. So we are now taking the pool back down to level out the ground again, after 3 weeks of work to get everything ready this is a huge disappointment but we know the importance of getting it level. Now the problem is my brother (who's garden it's in) wants to level out with sand (seeing as tho it's cheap and we have already spent lots of money on setting everything up) now I know that this isn't a very good idea as it moves under the pool and the pool could sink into it. We can't really dig down the higher end either because the grounds to hard and compact...so we are at a bit of a dead end on how to level it out now.