Hi All,
I posted this the other day about replacing my SWG, but decided to try to troubleshoot one last time.
Time To Replace SWG. Suggestions?
Here's where I was/am:
I'm a little stumped from here. The problem seems to be with the mini-board/not mini-board combo I'm guessing but all of the variables start adding up to make for tough troubleshooting. I"m hoping someone here that understands the big picture can offer assistance.
Thanks,
Lynn
I posted this the other day about replacing my SWG, but decided to try to troubleshoot one last time.
Time To Replace SWG. Suggestions?
Here's where I was/am:
- SWG hasn't been generating chlorine for a while. I've been using bleach and decided it was time to either fix or get it replaced.
- Cell was replaced last year. It wasn't generating before and new salt cell just kicked off more errors. That's when I gave up.
- Ping on the forums suggested I might be having flow issues since I got a new VS speed pump. That made a little sense to me based on some things I was seeing. So, I pumped up to my "cleaning" speed and decided to start the troubleshooting process again.
- The error I got at first was 123 - cell either needed cleaning or there were power issues to the cell. Cleaned cell, it went away.
- No new error codes, but I was getting "No Flow" reading on the display
- Read some stuff here that made me think I need to re-add the mini-board that I took off when I got the new salt cell and it came with the Sensor Indicator Module.
- Now I'm getting Error 125 and 194. I have the jumper on (I actually did this by soldering it after troubleshooting another time). My sensor module is set to Program B based on the firmware on my AquaPure. FIRMWARE: 07270A0405
I'm a little stumped from here. The problem seems to be with the mini-board/not mini-board combo I'm guessing but all of the variables start adding up to make for tough troubleshooting. I"m hoping someone here that understands the big picture can offer assistance.
Thanks,
Lynn
Last edited: