- May 16, 2011
- 1,180
- Pool Size
- 28000
- Surface
- Plaster
- SWG Type
- Pentair Intellichlor IC-60
We are finally getting ready to install the TurboTwister slide that has been sitting, assembled, beside our pool for months. The plumbing is in place with a capped pipe exiting the concrete pool deck where the slide is to be placed. This pipe is about 20' or less from the equipment where the line is controlled with an actuator.
My question is how to do the installation to minimize old standing water from inside the pipe from getting in the pool and messing up my chemistry. Or, if that is not possible, how to minimize negative effects to my chemistry if this water does get in the pool. Any ideas?
Thanks for the help!
My question is how to do the installation to minimize old standing water from inside the pipe from getting in the pool and messing up my chemistry. Or, if that is not possible, how to minimize negative effects to my chemistry if this water does get in the pool. Any ideas?
Thanks for the help!