So ive purchased this unit 2 years ago and converter it from propane to gas last year and installed it. Was able to use it once or twice last year with no issue. I removed the heater as i was doing some backyard work earlier this year and reinstalled it about 2 weeks ago. When i went to start the heater it would not start it would cycle 3 times and i would get the IF - ignition failure code. I took apart the ignitor and clean all the contact points as they were a bit rusted and u were able to hear the ignitor intermittingly not clicking. I reinstalled it and watched for its spark and it is present turned the gas on and i tried it again. Still wouldnt start and i can smell the gas. Looked on these forums and saw about the spider webs in the orifices so i took them apart and cleaned them as i did see the spiderwebs put everything back together ran the unit and it started right up. The very next day i tried to start the heater and once again it wouldnt start and the IF code came on again. I check for the ignitor sparking and it was there so i took it apart again thinking i didnt do a good enough job cleaning it and this time i even ran a fishing cable down to clean out the pipe connected it all back together and it started with no problems. I turned it of and on several times to see if it would happed again and no issue. Then the next day i turned on the heater again to see if it would work and again i have the same issue as it wont start. The spark is still there the orifice tubes are clear of webs and i can smell the gas from.the failed atempts to start. I even tried adjusting the pressure at the gas regulator by both increasing it 1 full turn and even decreasing it 1 full turn i put it back to where it was originially after those failed also. So right now im lost with what the issue can be since it works when i take it apart and put it back together just for it to fail again the next day. What should i try to do to fix this thing? Also the gas control valve is only 1 year old
Sent from my SM-G935T using Tapatalk
Sent from my SM-G935T using Tapatalk