Hey all,
I've just bought a house with a salt water pool and all is going well until this week. I am getting a check/clean cell alarm and wanted to see what someone had to say about my test results.
As for water chemistry:
CL 2
PH 7.6
CH 225
AL 80
CH 30 but will rise
Salt - 3400
SWG settings:
Software V4.4
Cell SC-48
Power level 1
Voltage 230 vac
1.5 A
SWG test result:
3200 Salt
89 Deg
32V 2.8A
35835 amp hrs
While cleaning the screen out a few weeks ago I noticed that the fins are clean but I wasn't really inspecting them at that point so I still need to get a good eye on the cleanliness and lengths of the fins in relation to each other. I will be cleaning the cell before the holiday weekend just for good measure.
This morning I turned the pump and unit on and the alarm didn't show up at initial start up. The purifier output level reached 30% or so and the alarm still did not come up. I had to leave so I can't say at what percentage it triggers the alarm but from yesterday i dropped the output to from 90 percent to 50 percent and the alarm was still active.
Any help would be greatly appreciated.
I've just bought a house with a salt water pool and all is going well until this week. I am getting a check/clean cell alarm and wanted to see what someone had to say about my test results.
As for water chemistry:
CL 2
PH 7.6
CH 225
AL 80
CH 30 but will rise
Salt - 3400
SWG settings:
Software V4.4
Cell SC-48
Power level 1
Voltage 230 vac
1.5 A
SWG test result:
3200 Salt
89 Deg
32V 2.8A
35835 amp hrs
While cleaning the screen out a few weeks ago I noticed that the fins are clean but I wasn't really inspecting them at that point so I still need to get a good eye on the cleanliness and lengths of the fins in relation to each other. I will be cleaning the cell before the holiday weekend just for good measure.
This morning I turned the pump and unit on and the alarm didn't show up at initial start up. The purifier output level reached 30% or so and the alarm still did not come up. I had to leave so I can't say at what percentage it triggers the alarm but from yesterday i dropped the output to from 90 percent to 50 percent and the alarm was still active.
Any help would be greatly appreciated.