I have trolled the site for a year & a half now, & gleaned everything I could about the best install for this pool. We leveled the ground to the lowest spot, added about 1/2" of sand to smooth out, 18x18x2" cement pavers partially in ground (even with the coming foam boards) all level to each other within 1/2" or less, Intex tarp, 1" foam boards double taped with Gorilla tape, another tarp, then pool. It all looked good & we began filling. When the pool was about 4" from full I noticed that the corners do not sit on the ground, they are all lifted off the ground. I can slide my entire hand under them, & one corner I can slide my hand back even further. Is this normal? We have had 3 Intex pools, but all round, so this was never a question.
We noticed a leak in the corner seams (but that's another thread) so we stopped filling. Pool is coming down tomorrow, but would love an answer for the next fill.
Thank you!
We noticed a leak in the corner seams (but that's another thread) so we stopped filling. Pool is coming down tomorrow, but would love an answer for the next fill.
Thank you!