I've set up my SWG to run on it's own timer slaved to the pump so I can get better control of my chlorine. Prior to this it ran whenever the solar water heating panels called for water. That was a lot.
So now I can set it by hours to run. (it's set up to only run when the pump is energized so as to not depend on the flow switch if the clocks get out of sync.)
My question is, should I set it to 100%, or is a break between cycles that say 50% gives it better for the unit?
Thanks in advance
So now I can set it by hours to run. (it's set up to only run when the pump is energized so as to not depend on the flow switch if the clocks get out of sync.)
My question is, should I set it to 100%, or is a break between cycles that say 50% gives it better for the unit?
Thanks in advance