I have a roughly 30X60 Ft Pool. I've attached images. It has a pressure port that is about midway between the ends on one side. This has a 1 1/2" cap as shown. The pipe coming out of the ground at the pad is only 1". This pipe is not hooked up. I think originally it was a pressure port that was running a pressure cleaner. When I bought the house it was disconnected and a Kreepy was hooked into the skimmer.
I would like to hook this line up to the suction side and run a suction cleaner, but I think the 1" line is too small. I think I'm left with reconnecting it to the pressure side and running a pressure cleaner? I could buy another kreepy and again try running the 60' length of the pool but am wondering if there is a better way.
Is this all correct.
Thanks kevin
I would like to hook this line up to the suction side and run a suction cleaner, but I think the 1" line is too small. I think I'm left with reconnecting it to the pressure side and running a pressure cleaner? I could buy another kreepy and again try running the 60' length of the pool but am wondering if there is a better way.
Is this all correct.
Thanks kevin