I noticed my pump was not turning on and upon further inspection realized that it was getting no output power from the pool pilot DIG-220.
I opened up the pilot and visually inspected the fuses which appear to still be good. I used a volt meter and sure enough where the power comes out of the pilot and directs to the pump I am getting 0 volts.
Is this a common problem? I cannot find a schematic for the main board inside any ideas?
I opened up the pilot and visually inspected the fuses which appear to still be good. I used a volt meter and sure enough where the power comes out of the pilot and directs to the pump I am getting 0 volts.
Is this a common problem? I cannot find a schematic for the main board inside any ideas?