I have the 18x9x52 intex ultra frame rectangular pool. It has been set up for about two months and there is something with the shapes legs on one side that has me concerned. I removed all the grass in the area where I was going to set up the pool. I dug the higher side down and used a 2x4 with a level to level the area. I put down 1.5 inch thick foam insulation sheets down followed by the ground cover. Under each leg I put two pieces of 2x8 lumber that were 12 inches long. When I lay a 2x4 across the top of the pool from one side to the other I am well within an inch of level. The problem is the water does not look level inside the pool and on the one side the legs are stretching the lower vinyl support to the point that the black cross pin is bending. The last two on that side are the worst and the others are not to bad. I will try to post some pictures. I'm not sure what to do. Should I just drain and reposition those legs closer in or will the same thing occur?
Thanks
Brian Csader
Thanks
Brian Csader