I've had an IC40 for about 4 months now working flawlessly. I installed it myself along with the intelliph system. Anyway, during my almost daily routine of checking cell status I noticed that the temperature read 75F last week. I thought that was odd since it's normally been reading in the high 90's or low 100's. It's been pretty hot the last couple of months where I'm located. So I cycled power a couple of time to see if when the temperature did finally show up, that it was something other that 75F. No luck. So since I discovered this last week, the temperature everyday has been 75F. This is also affecting the salt level reading since it's inaccurate for the given temperature.
My question is, does anybody know how to determine if it's the temp/flow switch(which can be replaced) or the cell itself causing the problem.
Any help or information would be appreciated.
My question is, does anybody know how to determine if it's the temp/flow switch(which can be replaced) or the cell itself causing the problem.
Any help or information would be appreciated.