It all began yesterday morning when I woke up and went to look at my pool etc as i normally do and i noticed on my intex swg the "low salt" red light was on, which i thought was odd but since we have a pool heater we have been using it more often and i have had to add more water since the kids keep splashing etc. SO i thought ok I will add more salt. looked into the imy intex manual and read i only needed to add 15kg when the " low salt" comes on. So i shut off my swg and had my intex sandfilter pump run for 24 hrs and then this morning i turned on my swg. Anyways, i noticed the water being cloudy ( which is obviously since we've been using it more often) , i tested the pool water and these are the results i'm getting
FC-none
PH-7.8
TA-160
CYA-0
I ran my swg for over 10 hrs and the "low salt" light is still on....obviously because there is no FC!!!! i'm currently cleaning my swg as recommended in the manual ( i'm thinking it's not producing either because it's dirty or it's broken)
My question is how do i raise my FC and CYA? do i need to add more salt? like a fresh start? and add the cya like i do when i open up the pool???
Please help i'm lost here....