relays

  1. J

    Intelliflo3 digital input relay control

    Is there a way to control the relays on the i/o board when using the external control programs? The only settings i see are speed/flow percentage settings... would be nice if it is possible... right now there is a 4 way air switch that turns the pump pump on and off by cutting the power, because...
  2. ewsb

    Looking for a Normally Closed (not NO which I understand is the std OMRON relay) for an Intellitouch Control Center

    Due to a fault in an existing Intellitouch i10 +3, I am looking for a relay that is the same as the supplied Intellitouch OMRON G7L-2A-BUBJ-CB-IN but with a normally closed rather than open output circuit. All else should be the same - e.g. footprint and voltages etc. as it will fit in the same...
  3. P

    Vsf flopro dry contacts.

    I have a customer with a 1.6hp vsf flopro with the jep controller installed on it. I want to use the dry contacts to control the 4 speeds that are built into the pump. I short the com to one of the four other options to start the pump. But when I do the dry contacts don't do anything, pump...
  4. O

    TriStar and aqualink rs8 compatible

    I purchased Hayward W3SP3206VSP TriStar VS Variable-Speed Pool Pump, 2.7 HP And I’m trying to connect it to the Jandy Aqualink RS8 I understand that they are not compatible with the low voltage wiring. So I followed the instructions for the relay installation method. I dedicated 4 relays -...
  5. X

    Connect SWG Powercenter to Pentai Easytouch/Compool Panel

    Hi, I have a SWG Powercenter that was wired into the GFCI and works great for the most part - I would like to connect it directly to the Pump Relays in the main electrical panel - I cant seem to find any instructions online for this. anyone have any instructions ? The manual that comes with the...