ignition lockout

I have been struggling to troubleshoot the cause of my ignition fault. When the heater first failed the blower would still run. I replaced the Air Pressure switch and Hot Surface Ignitor. I did see glow on the hot surface ignitor,but my burners would not stay on for longer than 7 seconds. I...

Hi all… So I’m new here but have read plenty of threads over past few years!! Having an issue I can’t seem to solve. First, I’m a remodel contractor by trade… but am NOT a pool professional. However, maintaining my own pool has been and is very easy for me. With that said, I have an older...

Unit is a Raypak RP2100 Mfg date 6/1998- Propane unit. Dormant and uncovered for 10 years. No propane tanks on site but they were there once. Unit powers on! Eureka!! - "SNS" code among others. She's coming alive again. Step 1: Clear leaf debris/chipmunk nests/birds nest/sticks etc. Step 2...

Hey folks! Hoping to get some clues as to what's up with an older Jandy LXi heater that's not working consistently. Been in my house for about 5 years - pool and equipment came with the house, and was clearly a few years old at that point. Heater outdoors, but in a covered area so it's not...

Hi, my heater is firing up, heats for 5 seconds and after several tries it stops and get the 3 blinks indicating “Ignition Lockout” I just replaced the thermal Regulator, Main Control Board, the ignitor, stack flue sensor and manifold bypass...was getting ready to replace ignition module but I...

Hello, I am getting the ignition lockout signal on our pool heater. No other error code no led on the mother board. I have already replaced the igniter but that didn't help. Could you please suggest what else to check and how? I didn't find anywhere how to check if the gas is flowing in? Thanks...