hayward vsp

I have new vinyl liner pool that was completed late last summer. I have one pump that just controls my water features (3 sheer decent and 2 bubblers). It’s a Hayward VSP 2.7HP. No filter attached to the feature pump. When I turn the pump on high, I hear a pulsating noise seemingly from the pump...

Hi all, My pool is a new pool (August 2022 completion date) and I have two Hayward VSP pumps. One (bubblers pump) was replaced a month or so ago because it stopped communicating with the Hayward Omni Panel and would shut off after a minute. The builder replaced it without question for free and...

considering switching my main filtration pump to a newer variable speed and there's so many pump options. The original pump is a 2 HP Hayward and so I'm considering the Hayward W3SP3206VSP TriStar VS Variable-Speed Pool Pump, 2.7 HP. Pentair VSP are hard to come by still. Pool is roughly 35000...

I adjusted my pump schedule this summer on my VSP based on information I gathered here. I've noticed on the lower RPM setting I get an air bubble in the pump pot. If I increase the RPM, it clears out quickly. I assume the air comes in at the floating weir but I'm not certain. I'm going to up...

Hey guys, last week I started getting this error on my display. The pump runs full force for about 5 min and then runs at a much lower level the rest of the time to the point where it doesn't seem to be flowing the water through the skimmers. Any thoughts or suggestions? I've looked at other...

Equipment-Hayward 1.85 THP Variable Speed Pump OmniLogic automation All installed spring 2020 by previous owner/ builder. Under “Select device” I see: MSP. HUA 00-4c-07-f4-a6 version R3.2.0 MP 01-47-07-f3-f8 version R 3.0.0 MSP id 85587 (not sure what this means) Problem: CommLoss...

I am in the process of finalizing my equipment choices for a new build and was told by my builder that a VSP in Texas wouldn't be a cost saver due to such warm temps in the summer. They are recommending a 1-speed, 2hp pump for a 15k G pool. They gave an example of a VSP working well in San Diego...

I'm new to the pool world and have run into issues with air in the return lines that the pool builder is being very slow to look at and resolve. My setup is below ground pool 25,500 gallons > Hayward TriStar VS 900 set approximately 4.5 feet above the water surface > Hayward SwimClear filter >...