fuse

I have a Pentair iChlor 30 that is just under 5 years old (installed Aug 2018). Today I noticed that no lights were on and my FC was way down. Went ahead and replaced the Power Center fuse (10a mini blade) and the new one instantly blew. Fuse remains good when the cell is disconnected. I know...

I have a 10 year old Hayward H400 FDN pool heater. It’s worked flawlessly for the first 10 years. This season I had IF (ignition fault) error and replaced the flame sensor because it would fire up but go out after about 30 seconds repeatedly. After doing this it fired up and continued to run. By...

i have a 230v/115v 3/4 hp pool pump. it over heats on start up and takes about 3 tries to start up. i am thinking of getting a new motor to replace the older one (as u can see it does have discoloration on parts of it and no the gnome is not right behind it anymore). Whrn i change it out i want...

My trusty SWG has stopped working. A LPS kindly suggested checking the fuse on the PP and bingo! Paying $0.50 when you're ready to shell out $1k doesn't happen often! The manual states using a 1.5a fuse. At the store, looking at the blown one I took in, they believed it was a 2a (not easy to...

I have an old (2004-ish) Hayward Aquarite T-Cell 15. Over the years I have replaced the boards, cells, displays, etc. My current challenge is a blown fuse.....not the 20amp fuse on the board, but the 2.5amp fuse on the mounted on the bottom of the control box (see photo with cap removed). I...

The fuse on my IntelliCenter has blown (and this needed replacing) twice in the last 2 years. My installer says that he has never seen this fuse go before. Does anyone have any suggestion for why this may be happening?