Search results

Sorry for the delay, thank you very much !

can you point out the K4 relay?thermistor ? just so o know what is being referenced( and i can compare to mine)

ah ! Got it , thank you !

good point, i have a REV C board in mine, same with his. Ill take a harder look and see.

I tried the steps again to change the AL-5 setting, it would not change, though i can still toggle between Fahrenheit and celsius/metric. i cut power and removed the board, double checked connection, seems fine aside from being a little loose... those plastic legs are not in good shape and...

Its always been loose like that. i am going to see if i can snug it up a bit but its on those plastic legs and the board just snap over the ends.

Yes, change the display to AL-6 the move the switch from auto to super Chlorinate...usually, it doesn't change it in this instance, going to try it again.

I tried that and it did not change, i am going to try it again.

Yesterday "inspect Cell" was on, while i was turning the system off i noticed that the display would flash and "jiggle" a little when i moved the switch or pressed the diagnostic button, seemed like a loose or dirty connection. I took the cell off and started a cleaning in a bucket with diluted...

Update, just before i wrote that post i had removed the switch and used a 240 sandpaper to sand down the contact area on the arm and clean(polish) the contact side of the metal switch arm. turned it on and came in. when i finished the post i went back out, flow light was off and generating...

I am curious, what makes a glx-flo switch go bad in an aquarite? What is the mechanism that closes and allows current flo? Suddenly today i am getting a flashing "no flo" I pulled it and it has some build up grime, ,very fine which i rubbed off with a finger, reinstalled, no change. If i pull...

Thanks all for the replies, i have seen the light, staying with the Aqua-rite and replacing the cell(which we found we can use a T-3, so cheaper, correct firmware and pool size of 11k)

very good, i actually found a T-3 for 150 on ebay with a 5 year warranty that looks exactly the same with a 5 year warranty as well, seller is out of Tennesse. (Firmware on the unit is 1.59 so should work, pool is 11k gallons.)

I didn't see a forum specific to ionizers . Apologies if this is in the wrong place. I have and aging aqua-rite system with a salt cell(t-15) that is likely going to maybe make it through summer( #2 cell). Before i purchase a new cell, ive seen some information on Ionizers , and im wondering...

at what terminals/points do i test the voltage/amperage on these units?(T-15)

Reasonable? can you link or offer the best place to buy the t-15 or equivilant? Locally they are 600-800

My T-15 lasted just over 6 years in Gilbert AZ( just east of Phoenix). It finally bit the dust last week , i ordered a TI3 Replacement Salt Cell from Pool Express. Installed and working flawlessly, time will tell.

Came across this board looking for prices for a t-15( almost 6 years old, running on a 12K gallon pool) running 6 hours a day on 75% in season, 4 hours on 30% off season, Phoenix area). i was suspicious last summer and had the cell tested at a local store and it indicates "failure",but i still...