Search results

Last time I had this type of issue the thermal regulator was replaced in 2010. Getting a code E01, r=05 and LED light 11 & service light goes on. Pulled the thermistor and tested with a meter and getting 8.5 on resistance/Ohm. Is there anything else I should test or is this a bad thermistor...

I researched previous threads on this with no final solution. So here is my problem. System will general fault "service" 120 code on the non cell reversing portion but on the cell reversing cycle I do not get this fault and system runs fine. When the issue arises on the normal cycle the...

Have a 3.5 yr old Jandy 1400 salt system and I have been getting now flow intermittently. Filter is clean, cell is clean and sensor was cleaned. Seems that it only stays on no flow for about 10min and then goes back to flow. Chlorine levels are good so it is producing. Any ideas on this issue...

Ok I replaced the check value but spa water is leaking down to the pool level each night. Could the be an issue with the Jandy valve actuator? I notice the other night when in the spa with it on that I was getting a little bit of flow out of my pool sunshelf bubblers and that the level in the...

My Polaris D'light color changing LED pool light finally bit the bullet a couple weeks ago. While I was somewhat satisfied with it for the past 4 years I felt that it really didn't produce enough light. So now is the time to make a switch and would like the recommendation of your experiences...

Tonight my heater was cycling on and off with error code of 128 r=5 code showing, any ideas? I seem to remember the last couple time this happened it was I believe the high limit switch or thermal switch. Can anyone also give me a walk thru on replacing what ever it might be. On another note I...

Seems like the past month I have been getting spearatic no flow readings and reading some of the posts on the Jandy SWG it seems a possible flow sensor but I don't want to replace till I'm sure. But hear is my question I'm getting flow reading, cell resting and cell reversing all on at the...

Looking to put in solar heating for our pool within the next couple weeks and would be grately appreciative for any reccomendations. I have narrowed it down to 3 manufactures but would like to know any experience anyone here might have with these or suggestions for the best one. I've heard...

Have a Hayward pool and spa light assemblies w/ Polaris LED and the GFI keeps tripping. If I reset the GFI and only turn the spa light on the spa light will work but if I turn the pool light on the GFI trips and both the spa and pool light go off. I took apart the pool light and bulb is good...

I've noticed over the past 3 weeks that the spa has been losing about an inch a night, about an inch below the spill way. I have shut the valve off the spa a couple days ago and it is slowly losing water. Called my original PB and they think it might be leaking around the main drain(s) which I...

Have a rental home with a 70'ish built kidney shaped pool approx. 3ft to 7ft deep end. Size is 20x16, approx. 14k gal. and 1.5" piping. Currently I have a 1hp Hayward super pump (new). I can get a Hayward C1200 for the same price as the C900, so my question is the C1200 to large? Can the 1hp...

I have a IG spa but I am not totally satisfied with the current spa aggitation. Spa is using the venturi system for air flow. I hooked up my 3hp shop vac to the venturi pipe and like what I saw. So can some one give me a good recommendation for a reliable quite 2hp blower. Also I've seen...