Search results

Perfect - thanks! Geoff

Wow - thanks for the input! Heading to a pump store at lunch tomorrow. Here's the motor label. Thanks again, Geoff

Hi All, Re Hayward MaxFlo VS SP2302VSP While undoing bolts to replace seals, the pump-end housing on the motor with the bolt holes where the seal plate is bolted broke. The metal that makes one of the bolt holes crumbled. See the photo and diagram. I can't find a part number anywhere -- it...

Taking all the advice to double-check above ground before suspecting the underground line, I ran a temporary from the main drain port on the bottom of the skimmer to the pump, bypassing most of the fittings at the pump -- with this the bubbles disappeared. So tonight I reconnected the...

Hi Stebs, Yes, I've checked the union with both the smoke trick and the water trick. Thing is, when I hear the water sloshing around that 90-degree elbow, makes me think the air is entering before that elbow otherwise it would be quiet. And if that much air was entering at the taped join of the...

Yes, that's vinyl tape. After checking them with water and smoke thought I'd put a few tight wraps of tape to see if that reduced the bubble count -- no change. Geoff

Hi All, I’ve been lurking through the site for a week or so getting good info as I troubleshoot my pool issue, and now I’m looking for some feedback/advice. The problem is an air leak on the suction side of the pump – see the bubbles in the salt cell and from the inlet. You can see there...