Search results

This is my 3rd board over the past 17 years and just put in last year. Started getting intermittent no cell power and no cell power 2 errors this weekend. Checked the k1 relay and no burn marks. I went ahead and resoldered the pin anyway. Can anyone tell me what this circled area on the board...

Was getting high salt/amps error yesterday with the numbers jumping all over before when in diagnostic mode before shutting down. I was getting a no cell power 1 error. I have soldered the k1 relay many times in the past. I was going through the Hayward trouble shooting worksheet and getting...

I just had a tristar 950 installed and it controls my filter/in-ground pop ups. My waterfall is on a separate super II pump. I was looking to see if its possible hook up and run the waterfall with a 2 speed pump to have better control(lower output for sound) of the waterfall. I don't want to...

I have been trying to find out why my controller box/transformer has been running so hot since my new 950 vsp was installed last week. I replaced the transformer and still is hot. I was looking through the installation manual and stated the pump shoukd not be wired to the filter relays but...

Have been working on my pool a lot after having a new Tristar 950 installed this week. My electrical control box is very hot to touch, particularly in the upper corner where the transformer is. I have not noticed it before. I tested the transformer outputs which should read 2-2.9 ohms. My...

Just purchased and had a new Hayward Tristar 950 VSP installed last week. I have a prologic board(G1-011049e-1) running main software 4.20. I had this board replaced 9 years ago under warranty as it was originally an aqua logic. I have an aqua logic display. After install, I was only able to run...

I drained and acid washed my pebble sheen salt water pool this past weekend. I was told that it was approximately 15k gallons. It is a free form play pool but the actual dimensions are slightly larger than the plans show (about 2' longer and 6" deeper). It is about 37' long with 3.5 /5.5 /4.5...

I finally purchased a 1.5 hp 2 speed motor to replace my single speed hayward super 2. I have an aqualogic ps-4 for control with an available aux2 relay. I understand the wiring schematic but want to know the correct way to combine the line in and common wires to the new relay. Should I splice...

I have a couple of pool pump questions before I buy. I am trying to lower my energy cost here in Arizona and the pool pump would be a good place to start. I currently have a 15k play pool with an inground cleaning system. I use a t-cell-15 for salt chlorination and c4025 cartridge filtration. I...