Search results

Hi, Looking to purchase the cyclone and trying to see how I can modify the lid for easy blowout. I noticed the intelliflo lid has a curve as well as supporting ridges underneath which makes the seem hard to drill keep flush for the locknut and gasket. Has anyone successfully modify the lid...

Do you have a pic of the skimmer and vacuum line? Could it be that you have a pin hole in the vacuum line where it's sucking in air?

@cowboycasey are you saying right after the heater but place the vertical kit horizontal or place it like the second pic within the tight gap? Thanks!

Hi, I'm thinking of converting to SWG. I have Jandy automation and Pentair VS Intelliflo pump. For easy DIY I'm looking at Circupoll RJ series. I have two possible location. The first being right after the heater but I would have to put the flo sensor before the cell. The second is a...

Thank you! I'll give them a call.

Do you remember where. you got it from? Conduitrepair.com has a min of 6 requirement. Also is it 1" conduit? Thx!

Hi, I found a split on my conduit. Looks like the previous owner tried to repair it by inject some type of caulking inside it. I was wonder if there's a bracket I can purchase specifically for this. I didn't see any on amazon. Can I use super duct tape? Thanks!

Pm replied

NJ is not that far, I could meet at a midpoint. :)

Bump - taking up space in garage. Make me an offer.

Hi, I been meaning to setup my stenner pump and tank system which I purchased as a barely used unit. Unfortunately never got around to it and didn't open the pool this year. Looking to sell it as we will probably go with salt system after renovation next year. This is 120v unit. Looking to...

Hi Jillp913 - can you pm me who you used for the remodel? I'm needing to remodel soon. My tiles are falling off and coping breaking. Thx!

Thanks for the responses. I did some more checking last night and measured the voltage from the panel to the controller. There was power from the panel but no power at the controller. I found the line was spliced before entrance to the house. I redid the splice and now it works.

Hi All, I have an original controller that came with the pool about 15 years ago. It was built by Blue Haven and the controller says BH6100 which I believe is the same as Aqualink RS8. Last night the controller was dead, I tried to reset and looked at the wiring on the controller side. It...

My pool looks good but the tests says otherwise. CYA @100. I'm going to inquire with the water company regarding cost for 12k gallons of water.

Thank you bmoreswim, that makes perfect sense. My kids were playing basketball and running back and forth hence cause the paver shift.

Thank you everyone for the warm welcome and the helpful links. The pool is cloudy and they did pour 5 gallons of bleach yesterday. I'm letting the pump run 7 hours a day. Unfortunately I didn't keep my water level low enough this winter and the tiles are falling off. I'm waiting for my pool...

Thanks Jason, I was afraid of that. I was hoping I could use some type of glue/filler.

Hi All, We just opened our pool today and tiles are falling off and red coping tiles are chipped. I already purchased pool putty epoxy for underwater tile repair. Can anyone recommend ways to fixed chipped coping tiles? They are the typical red bullnose. I've attached an image...

Hi All, I've been lurking for just under a year. We've moved into our new home July 2014. I just ordered my tf-100 test kit. Our pool was opening today and I'm ready to start maintaining my pool. Hopefully, I'll become knowledgeable enough to replace equipments as they start to fail...