Search results

Thanks for replying. I was mentally exhausted and assumed that since the board was fried that meant the display also had to be fried and who knows if the box and wiring is damaged or not. Next morning I hooked the original board up and saw that the display worked which meant the box was ok. I...

The metal inside the box at the area where the power wires sparked definitely has contact burns. Most of the rest of the wire that plug into the board are covered in soot. I threw the fried board in the trash. I’ll probably have to get a new box and not just another board and display board. Not...

I’m positive the colors were matched. I suspect the back of the board touched the metal. Would that cause it to blow like that? The board was fried. The display board would also have been rendered useless? How about all the wiring inside the box. I’d probably need to replace the entire box?

This is the photo of the one I replaced. I wired it exactly like that. The replacement came with a set of red and black wires attached but I used the ones that were already in the box. Pinch a penny installed the original in 09 and I thought I could just connect it the way the old one was...

Hi, i swapped out the board with god-pcb-rite and took photos of old unit beforehand. Once I powered it up and the display was working, I went inside for a few minutes, when I came back no power and pump wasn’t running. Ckd breaker but wasn’t tripped. Back outside and flipped power off, when i...

everything was under warranty so they came out... said the box needed to be reset, said i must have pushed the super chlorinate button after i'd cycled away from the salt reading... i told them i didn't cycle away from it... why would i? truth be told, i'm not sure if i did or not... think that...

the place i bought the unit from tested the water... I cleaned the cell, but it looked pretty clean already thanks

I have a swimpure plus purchased 2 summers ago... I recently had the water tested, added the salt and chemicals and then yesterday noticed a little algae starting to show up... I figured what the heck and decided to superchlorinate for a while... soon as i flipped the button/switch the read out...

I had the Goldline Swimpure Plus installed a little over a month ago... at $800.00 plus salf and install fee, it was kinda pricy, but it's working great. No problems with my sand filter.

In case anyone was wondering. P.Penny guy came out while I was at work and now the correct lights are lit and the unit shows 3100 as the salt reading. I asked the lady what the guy did. She said, he said he made some adjustments to the box. I was wondering what kind of adjustments he could've...

it gets worse... when they came to install, they determined my pump motor was defective because it was throwing the breaker at the box. They replaced that at time of installation of the SWG. The pump had been running since Friday when I turned it off this afternoon. When I turned it back on it...

Thanks for replying, guys. The installer turned it on and left it on. I didn't read the sticker until this morning. You'd think if it needed more salt then he would've realized it while he was there. Then again, with all the units this guy's installed, he should've known to keep the thing in...

Hi, I had a Swimpure Plus installed yesterday. The guy went over the panel with me before he left and said not to worry about the High Salt reading, that after a while it would go away and would only have the top two green lights, Power and Generating. This morning when I check though, the only...