Search results

I have an in ground pool with a Jandy Zodiac Flopro 1.5 self priming pump. It turns on briefly, maybe 30 seconds, then will turn itself off. I then have to wait a few minutes. I will hear a click and I can turn it on again. The cycle repeats. It is not tripping the breaker. At first I...

We have a 2013 Hot Springs Flair hot tub with the ACE Saltwater System. The cells die too quickly and are too expensive to replace. I would really like to just remove the cell and stop using the system. The dealer is quoting close to $200 to remove the system, which I think is absurd. I...

Hello, I hired someone to open my pool this year because I was just too busy. I'm not sure what all was added during the initial shock. I can tell you it is sparkling clean! Unfortunately, the free chlorine is off the charts. In my test, it is turning a burnt orange color instead of yellow...

I have a hot springs spa with an ace salt water system. Everything has been running fine and chemicals have been balanced withing varying ranges of normal for over a year. I went to do my weekly check yesterday and the clorine was gone. I added a little granular shock and turned the output to...

I had a liner pool installed last year. Last night I felt a couple rocks under the liner near the steps. It is normal to have some small rocks migrate in? We don't have a water issue and there is a sump under the pool. We run the pump a couple times a year just to be sure there isn't any...

So, I'm fairly new to all of this. I did go through the SLAM process about a month ago and turned my green pool back to clear. Then we went out of town for 4 days. I set the auto chlorinator to feed Trichlor tablets while we were gone. The pool seemed fine when we returned, but just not as...

So, I have my TF100 and my pool is no longer green! now I just can't seem to stop testing my water! Tonight's tests are: FC-5 CC-.5 CYA - 40 CH 300 TA - 130 PH - 7.2 I've been slowly letting my FC drop after completing the SLAM process, otherwise my tests are pretty consistent day after day...

My SLAM process isn't quite done yet. Very clear water, but just a little green in the deep end. My readings after returning home from work are: FC-8 CC-1 TA-130 PH- 7.2 CYA- 0 Do I add CYA at this point, or wait until done with SLAM process?

My 13,000 gallon vinyl pool turned cloudy and greenish this past weekend. I only had test strips to work with, but started SLAMing my pool the best I could. I have been getting positive results with only a little green / cloudiness in the middle of the deep end. My TF100 test kit arrived and...

We finally have our pool and all was fine for a while... Something went haywire. Pool is very cloudy and I am struggling with Chlorine readings and it just keeps looking worse. I replaced the cartridges in the filter and took water sample to store. They told me To increase PH then shock. So...

This is the first time I'm closing a new pool in Ohio. I've been told I can just use my automatic cover as my winter cover, but have concerns with weight of snow, and reduced water level to support the cover. Anyone have experience with this scenario? Thanks for the advice.