Search results

  1. S

    filter control valve - parts

    Dave, was not trying a "drive by, or an endorsement, which, by your posting the comments you seem to have understood. I will not even forward an e-mail without some research on my part. Anyway, thanks for clearing up my confusion on Hayward vs. PacFab/Pentair. I was confused due to the...
  2. S

    filter control valve - parts

    F.y.i all Went to BBB re In yo Pools. they are an internet site that supports other dealers. Read most of the BBB complaints and looks like in yo pools.com did try to do as much as deemed reasonable to remedy each issue. As is often the case, BBB determined that most "issues" were customer...
  3. S

    filter control valve - parts

    sorry all, ... not inyoupools.com, but inyopools.com. Have to do some research on that one. Thomas
  4. S

    filter control valve - parts

    So far Inyoupools.com "cheapest" on parts by almost 1/2, but look like they aftermarket products. Pool zoom look to b "pentair" parts. Ebay "cheapest" but will not buy from a never known, fell off a truck, source. Thomas
  5. S

    filter control valve - parts

    Who does TFP recc for parts. Can find on own, prefer to "brag" on you guys and pass on info to dealers.(never hurts) Thomas
  6. S

    filter control valve - parts

    Mr Dave, you r a gentleman and a pool pump multivalve scholar. It has been a pleasure! Thomas
  7. S

    filter control valve - parts

    found on Pool Zoom, shows Pentair.
  8. S

    filter control valve - parts

    Also, THANK YOU!!!!!!!!!!!!
  9. S

    filter control valve - parts

    Pac Fab, Pentair, or Hayward. do you rec. any sites/distr/retailer. Can pass ur rec on to them.
  10. S

    filter control valve - parts

    will try. picture w/o handle.[attachment=2:isg91o3m]1.jpg[/attachment:isg91o3m] Went to hayword site earlier.. and found ... Hayword has inlet/output pipes "stacked" these are offset @ aprox. 45 degrees[attachment=1:isg91o3m]2.jpg[/attachment:isg91o3m] other...
  11. 3.jpg

    3.jpg

  12. 2.jpg

    2.jpg

  13. 1.jpg

    1.jpg

  14. S

    filter control valve - parts

    Have Pac-Fab(Pentair?) sp-710 sand filter control, rated 75 G.P.M., 6 position ... there is the # 5037 on lable @ 3:00 position Leaks very slowly(for now) out top of unit, under handle. Also, handle broken, but not cause of leak. have hunted parts but none found under sp-710. Figure while...
  15. S

    Algae prob. on sides and bottom, sweeping all the time....

    Re: Algae prob. on sides and bottom, sweeping all the time.. As a rough estimate ... how much for a SWG on a 36k in ground pool. Am very "handy" do most of my own repairs, can or should I install the SWG myself, and who/what brand do you rec.? Thanks!!!!! Thomas
  16. S

    Algae prob. on sides and bottom, sweeping all the time....

    Re: Algae prob. on sides and bottom, sweeping all the time.. ok, Tested pool water w/ 1/2 filtered tap water and 1/2 pool water shows CYA is 60. Assuming our Atlanta water does not have any CYA in it, I guess I'm @ a CYA level of 120. 36k Pool ... how much should I drain? Thanks Thomas
  17. S

    Algae prob. on sides and bottom, sweeping all the time....

    Re: Algae prob. on sides and bottom, sweeping all the time.. ok, will not "dilly dally" and get right on the acurate CYA # today. Then will repost soonest Thanks for the swift reply!!! Thomas
  18. S

    Algae prob. on sides and bottom, sweeping all the time....

    my 1st post, discovered you in Costco Mag. Have 36k, IG, Gunnite, Sand-Pentair Triton TR-60 60 gal/min 300 lbs sand (new sand), 1.5hp single speed 3450 rpm pump, pool built aprox 1970, dolphin robot cleaner. Outdoor pool, surronded by trees. Atlanta, GA. 30327 pool temp now 81 have heater...