Search results

Would there be an advantages if I removed the reducers?

my plumbing has a couple of reducer bushings from 2 to 1.5 at the pump suction side, swg outlet and spa outlet sides due to pvc repairs. Is that bad for flow rate, should I remove and fix them. Or not an issue. Thanks

Anybody here have the poolside tech attendant system?

Those of you that have automation, you’ll feel like it is worth the hefty cost for a basic spa/pool combo without any water features?

I have the spa return side very slightly open now, I did not plan on getting the relay card for the Intelliflo, was just going to keep the salt cell wired to the old timer.

Ignore the single speed pump I am replacing it with a intelliflo3

Need some equipment advice, currently don’t have automation so spillway is running all the time when the pump is on, I know that can raise ph. Constantly out of town for couple days for work, so unable to adjust valves manually everyday. do I need to install an automation system or constant...

thanks what may be causing the push pull valve leak from the top of it?

I think it is the titan 586090

Hello, Need to replace the de filter grids in my old filter can, what part number do I need to order. Also the plunger valve recently started leaking at the top, is there a o ring I can replace or do I need to replace the valve? Thanks

Hello have a lot here diy installed a intelliflo3 pump which really gets no warranty, and do you’ll think it is worth the risk. Thanks

OK CYA wise do I need to raise it to 60 or keep it at 50 for now and just keep the FC at the upper range? Thanks

Maybe 7.8 or 8.0?

This good?

Would you’ll think this PH is 7.8 or closer to 8.0?

Hello first time trying to balance all my chemicals. which ones I need to correct? I know the CYA need to be around 80 for SWG and ph needs to be lowered a bit. Thanks FC: 4.5 CC: 0 PH: 8.0 TA: 80 CH: 225 CYA: 50 SALT: 3400 CSI: 0.03

what product from hardware store shall I use to raise my CH or is the calcium hardness increaser from pool stores only reliable source?

Hadn’t done a slam yet, my pool bottom and steps has a yellow color film on it, when brushed it forms a cloud, I thought that are signs of mustard algae.

would using cal hypo as slam chlorine be better for my case since i doesn’t raise salt nearly as much?

Currently have some mustard algae, looking to do a slam, currently have low CH and correct salt level. Do I need to get to optimal CH level before or not. Also if I use liquid chlorine to slam would it not raise my salt level to too much above the optimal range? Thanks

Anyone here in the past purchased a intelliflo3 pump from a online authorized pentair dealer and got it professionally installed locally, does that quality for the 3 year warranty, or need to be purchased locally and installed both? Thanks