Search results

Thanks for the reply. The jandy transformer has a sticker that states 120v in, 240v out, 2.5amps. The door bell transformer is 120v in, 24v out, 20va. Thanks

Hi, My jandy Aqualink control panel stopped working all of a sudden. Fuse is fine and I tested 120v power coming into the transformer which is also fine. When I tested the 24v output on transformer it appears to be dead. The original transformer is a jandy RO466400 which is 120v input and 24v...

I installed my pump myself. It's pretty easy to do. The wiring was probably the easiest part, just pay attention to how the original one is wired up before you remove it and you should be fine. BTW, if it's working fine but is just noisy you might be able to just rebuild the motor (replace the...

Re: Leak from sand filter clamp area. Just installed new 0ri Ok, folks....when I got back home I fired the pump on again and after a few minutes there was gushing water all over the place!!!. I immediately shut it down. Apparently there was now a 4" or so long crack in one of the band clamps...

Re: Leak from sand filter clamp area. Just installed new 0ri I am away from the pool right now, I will have to check the gauge when I get back home. I will also try it on recirculate to see what happens. YES...I did install unions!!! I was very close to re-gluing the pipes again...that would...

Hi Guys, I have a SP0714T Multi Valve on top of my sand filter. A few days ago I noticed there were two streams of water coming from where the screws/nuts meet on the clamp that holds the multi valve to the actual filter. I went to the local pool store and bought a new o-ring came home, cut the...