Search results

I paid $1,500 for Salt water generator. with a 5year warranty on cells.

Has anyone heard of CL Free? I have a buddy who has ozone and paid about 4,000.00 for the unit. But I hear there's a system out that makes pool water clean and drinkable. Has anyone heard of it? I read it uses co2. I would like feedback, thinking of switching from salt water to fresh water. Does...

I was skimming thru this post so not sure if anyone has asked: is there a heater connected to the pool?

What's the width and length of new pool?

Re: Cannot change from Pool to Spa Mode with Jandy Aqualink It happens, these new electronics nowadays. Last month my spa would turn on and be hot and ready at 7pm. along with the lights, found out my neighbor bought same system. Not that i really minded but Had to change one number on the...

Re: Cannot change from Pool to Spa Mode with Jandy Aqualink Check all connections, power, wires, battery. You may have a bad circuit board.

Sounds right on your part, I agree with "poor workmanship" even with pool light angle showing imperfections it should still look uniform. They should have included the start up at the price you paid. There's no excuse to scratch the tile. Unless you wanted them to "try and clean the tile", but...

Re: Cannot change from Pool to Spa Mode with Jandy Aqualink There's a 9v battery in main panel, it won't hurt to change it. That could be the problem with the remote not communicating with the Main control. Because different functions pull more power to use than other functions so that would...

Are they licensed??? Did they remove the plaster compleately down to the gunite? Also, was the plaster applied in two coats measuring up to 1 1/2 inches thick? As soon as the plasterers are done you have to start filling up the pool immediately. The plaster will absorb the water and even itself...

Re: Cannot change from Pool to Spa Mode with Jandy Aqualink When was your system installed? to cover the basics: replace the battery in the PDA. Place the system in Auto using PDA, go to the main panel and reset the time and date, after this is done check to see if pumps are being turned on...

Re: Cannot change from Pool to Spa Mode with Jandy Aqualink What model pda do you have, I have rs6. When you go to the Aqualink main controller/timeclock what lights are on? will it work if you press spa mode on the main control panel? I had to hold spa down for 5 seconds to reset it and did...