Search results

Hey guys! It's just amazing! I got my pool to 82f in just 6-7 hours. The pool had a temperature of 64f in the beginnig. The outsidetemperature was 72f. And the pool wasn't covered and the sun wasn't shining that hard. I think wenn I got my new coversurface and its about 84f outside with shining...

Thank you all for your help! I will test my heater on Friday, because in Germany it will be a bit warm then! I will inform u on Sunday ;)

An authentifacted Electrican filled up the R 410! This means that i should just run the machine for about a couple of hours to see what happens? ty! EDIT: I forget to say that I got a small Pool! Just 11-12k liters! My Heater pump got 16k Liters an hour!

Hey, guys! Its me again, and my Heater is finally working! After hours of work, he running now, but he is not getting to temperature?! My Pool is 62F cold and the heater just give's 68F out! It dont care if i set it on the Pool or Spa mode, in every single mode the Heater just give 68F out! In...

Hey! Today is recieved my new Circuit Board and Potentiometer! All Control Lamps are running, and when I start the Machine, all the LED's are blinking and the Fan is running, but nothing else! The machine doesnt give any other noises! I read that afer 90 Seconds the compressor should be running...

Hey. Yesterday, an electrican was here. He just testet all the components and he said, the Potentiometer is crashed hard! The whole plantine is black and smell very hard. My question is now, how mutch ohm (?) and Watt {n} the Potentiometer got? I would buy a new one in Germany, cause the...

Yes, my Heater got this curcuit breakers too. So you turned all of them 10 minutes off and then the t-stat worked again fine? How did u turned them off? Thanks.

Thanks :) Can you describe the " I just killed all the circuit breakers on the pool panel for about ten minutes then turned them all back on and it reset itself." part more nearlier? My fault at the beginning was, I thought that the plug from the TB2 was the power supply (there was written PO...

Hey Mates :) First of all, sorry for my bad English, I came from Germany. I've got a big problem with my Minimax HP 400. All control Lamps :Control, Pool, Water Press. Ok are blinking. But the T-Stat Lamp wont blink. Did the Thermostat crashed? The Unit didnt run at once .. What can i do to...