Search results

heater is about 7 years old.No issues to date other than sensors needing to be replaced from salt water corrosion.

looks like it's limited to the bracket but to replace it appears you have to disassemble the entire heater.

kinda hard to see. thinking i could put a piece of metal over the bracket and silicone it down.

Looking for any recommendations on what to do here. So in the process of changing my igniter on my Max Etherm 333 the metal around the igniter failed. As you can see in the photo there is now a small maybe quarter inch gap allowing heat to escape. The heater is working now but i'm afraid this...

For the record not an electrician but the pool repairman also said it was a voltage issue. I do have a fluke to test voltages if you want to walk me through where the leads need to be.

Inside the connector coming from the fenwell to the igniter.

Was measuring inside the connector itself.

Is there anything I should replace other than the Fenwel box? Heater won’t fire and I have replaced all Sensors and the igniter. Doing some basic electrical and found the igniter is not getting voltage. I have had some wiring damage over the years but the splices appear to be ok and the heater...

So apparently some rats thought it would be a good idea to nest in my heater control board and chewed through several wires. Does anyone know if wires can be bought individually or if you have to purchase the entire wiring harness. The wires damaged are in the attached photo. If anyone could...