Search results

0.0004 Ohms is close enough to zero for me . 😁it is not superconducting solder.

Fixed! I just soldered the pins together. Tip: Have a decent voltmeter handy and measure the resistance of your solder using the pins at the opposite side of the board as your solder. My first try I had 12 mOhms of resistance and the system still operated in T-5 mode. On my second...

The rain finally stopped this morning and I pulled off the display ( I did not realize it was so easy). I found J4 but there is no jumper or pins... just solder points (see photo). I have soldered PCB previously but I just wanted to confirm I should jump these pins to set the board to T-15. I...

Water temp 84 4800 salt 24.4v with 5.35 amps to cell al-0 Set at 23 percent R1.45 there is no option for T-cell setting with this firmware. I will pull the display board off tomorrow. Thanks!

Hi, I’ve been trying to troubleshoot my Aqua Rite G1-939013a with version 1.45 firmware. I am using it with Hayward t-15 cell. It is showing very high false salt readings(4800 reading, 2800 tested at pool store) . I’ve swapped out the cell with my neighbours t-15 and it behaves the same...

I am pretty sure my older version aquarite system is set for a t-5 and I am using a t-15. My salt readings are displaying 4800 when actual is 2900. It occasionally locks out for false high salt. The problem is I can not locate the j4 jumper on the PCB. Can someone please direct me? Photo of...