Search results

I have a Jandy Aquapure 1400. I have replace the cell and the flow sensor last year. Recently it started to display an LO on the outside panel. After turning the cell off it will display service codes 145, 172 and 180 along with the LO. I went through the troubleshooting manual and got the...

The controller for my pool periodically gives a general fault of no flow and says to check pump. I can see that the water is circulating in the pool and overflowing the spa. My controller will display the pool water temp and the salt content just no give a flow signal. Is there an issue with...

Is anything other than shocking necessary after pulling a couple of dead possum's out of the pool. Tested and adjusted the water yesterday afternoon and found them this morning.

Newbie question. When should I be measuring my chlorine levels, after the pump has run all day or in the morning before the pump comes on? Normally I run the pump from 7am-3pm. Most recent numbers are: FC: 7 CC: 0 pH: 7.6 TA: 100 CH: 350 CYA: 70 I know the chlorine is a bit high but I started...