Search results

I resolved problem. Another post said problem was resolved by swapping wiring connections. So i tried this now everything is working. Basically what this means for my easytouch system, i needed to follow the manual directions for intellitouch not easytouch

For anyone following this thread. Switching the RS485 wires on the motor solved my problem as well. So if you follow motor directions and it doesn’t work. Try switching wires ( easytouch yellow to motor black. And easytouch green to motor yellow). As i am writing this i noticed this was...

Thanks. Yeah i thought that was a bad idea so i fixed that today. But still not working

Could you elaborate on the wiring being reversed. Instructions say yellow from panel goes to yellow on motor. Are you saying it needs to go to black on motor?

Thanks for the reply. I am using a cat 6 cable. 24 gauge i think. I am using just the green and orange ( as yellow). The pump works fine with builtin schedules but when i flip dip switches for schedule D (automation) and hook up cat6 cable per instruction for Easytouch. Pump does not...

Just installed this motor on what used to be a single speed whisperflo pump. It works fine with builtin schedule b but when i set the dip switches for communication with The Pentair panel pump is not turning on. I am using a Cat6 ethernet cable and i have run it through the same conduit as...

Getting ready to do same conversion. Do i need to buy a RS-485 cable or is there one already lurking in the easy touch panel?