Search results

Thank you for your help...now for my next question... The 12Volt light that I have has a standard 3 wire cord (similar to the 120v light) is there a specific transformer that works with this kind of setup? Is this a 12 voltAC light, or 12 volt DC light?

Ok, so my pool build is almost 100 percent compelte, except for the pool light. I have an inground vinyl liner pool with a hayward Niche, I have a 12 volt light that I am going to install into the pool and with the instructions it shows a required #8 awg COPPER WIRE to be ran inside the pool...

Hey Guys, I need some help in a bad way. For some reason whenever I vacuum my pool for some reason the head on my multi port valve lifts off the spider gasket and water "pours" out of the waste line, also whenever the pump shuts off I can hear air being pulled back into the filter through the...

The diagram is only for single 220V feed to the motor because the switch is on the back of the end cover. I need to remove that switch and wire the pump so the SWG can control the speeds.

I have the two speed relay in the Aquarite and it is very easy to set it up to run the two speed....my question is about wiring the motor itself. How do I wire it so the controller takes the place of the switch?

First the normal...love the site and I have found a ton of good info..I searched but cannot find a specific answer to this question. I have a two speed hayward pump with the switch on the back cover. I also have the Hayward Aquarite SWG plus that can control both speeds of the pump. I...