Search results

i have a hayward gl235 solar controller, the check sensor light stays lit (manual says it's the pool sensor not the solar). I traced the wire and saw it was broken on the ground. I wired it back together but still stays lit. then I checked it at the circuit board with a volt meter. 0 volts. then...

tampa, florida it's an indwelling pool surrounded by a concrete patio movement could be possible. the ground here is very soft/shifting and sink holes are all over the place i'm going to try the liquid nails thanks!

until i get around to replacing the coping can I patch the crack with silicone? or cement patch? the pool/coping is at least 7 yrs old. probably 20 yrs, it came with the home the broken piece on the bottom came off in one piece thanks 2nd photo is upside down, sorry

i looks like it's leaking from the seal sorry the pic is upside down

I am hoping you guys have an answer for my leaking pump pump housing is hayward jacuzzi magnum. pump is AO brand 1 HP. it came with my house so i am guessing 10 yrs old 2 yrs ago I changed out the pump housing because of cracks, didn't take apart the diffuser. i noticed on the end of the...

pool is 20ft by 10ft, sloping in the center with 3ft ends/5.5ft center. everything was fine until I ran out of trichlor tabs, chlorine level dropped to 0 and started using the trichlor plus tabs instead. here's the reading.... total hardness- very low TC 0 FC 0 ph <6.8 alkalinity 180 stabilizer...