Search results

Following this thread too. I like most of you, have hit the point where most of my Globrite's have failed (pool built in 2018). I'm weighing up going with the Microbrite-Gs, or the Florida Sunseeker (@Comeby I think you need this adaptor to use in your Globrite niches - but yours should have...

I know this is an old thread, but in case anyone else finds it through a Google search, I can confirm this ratchet set work perfectly with the 7/8" drain plug. https://amzn.to/3T65eKG

Sooo...after the 'great freeze' of 2021 (second pic) it was clear that the tile on the waterfall was starting to separate, mostly near the corners, and no doubt due to frost getting under it. The tile on top has already been replaced and regrouted with an epoxy grout, but on the sides, it's the...

OK, next question, nowhere has stock of the parts (either the basic kit 474200 or full set 77707-0016), most places are sating 'months' for new stock, I assume they're just drop-shipping from Pentair directly. Is there a way to repair the manifold? It's a tiny, hair-line crack, but I'm not sure...

Thanks, those are great videos; I didn't need to, but I ended up watching both of them all the way through, I wish I could find a pool guy like that! Our heater is only 2yrs old, so I'm hoping it's just the manifold assembly, but will pop a bolt or two out later to check that.

It was a bit nippy here in TX the last week, and now the ice has melted, I'm trying to determine the damage. Unfortunately we lost power in the middle of the night, so by the time I got to it, everything was frozen solid. The Flowcell is wrecked for sure (I don't care, it was never great) , but...

Thanks, tried that, they're owed money, but apparently that's still not incentive enough. I've got this far, happy to continue, the more I understand it, the less dependent I am on unreliable suppliers, so I'm ok with that. Just looking for technical guidance :-)

This is starting to drive my nuts, as it seems like I've tried every configuration, but I can't get the acid to dispense. The only thing I've not been able to rule out is the actual motor in the acid pump, but the wiring at least is ok, so I assume it's not at fault. Quick caveat: The pool is...

I've been getting these codes for a while now, and it's obvious that no chlorine is being generated even when it's set to to 100%. The cell is less than 2yrs old, it hardly has any scale, and the sensor is clean. There is a voltage at the cell pins (around 20v). The one thing that looks like...